Big Bike Trunk and Saddlebag Lights Tips
Revision: 04/09/200
Introduction:
I'm a picture person and the installation instructions that came with the Big Bike Trunk and Saddlebag lighted molding lack some decent diagrams and/or pictures. I thought I would take a few pictures and share them with you. I have never installed trunk or saddlebag moldings on a Wing and it took me a little over 2 hours to install. If I had to do it again I think I could do it in less than an hour. Installation was not too bad. It would have been much better with better instructions.
Installation:
 |
I had to pull the wire harness out and removed some electrical tape to expose the wires. |
I tied the two hot and two grounds together to get them ready for the connections. |
 |
 |
|
 |
|
 |
The wires from the saddlebag lights hang and are in the way. I had to fine a way to route the wire so they would be out of the way. |
I made some tabs out of electrical tape and punched some holes in them. |
 |
 |
I used the turn signal housing screws to hold the wires out of the way. |
View of the trunk light strips. The wires are routed from the bottom and up into the turn rear lens housing. |
 |
 |
|
 |
|